Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Pico Rivera?
Spring replacement in Pico Rivera typically costs $180 – $340 per spring, installed. Most homes here have a two-spring setup, and because springs wear at the same rate, we usually replace the pair together, which puts a full replacement at roughly twice that: about $360 – $680. The written estimate sets the final price, and the estimate itself is free.
If your door slammed down this morning or you heard a loud bang from the garage, that’s a broken torsion spring, and it’s the most common spring call we get. Call (866) 618-5424 and we’ll get you a number before we touch anything. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- One spring: $180 – $340. A matched pair: about $360 – $680.
- Most Pico Rivera homes have two springs, and we usually replace both at once.
- Spring work is dangerous. Torsion springs store enough force to cause serious injury, so this isn’t a do-it-yourself job.
- We work on what you already have, whatever brand is on your door or opener.
- Free estimates. The written quote is the price.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers break down for a typical spring job in Pico Rivera. These are estimated ranges for our market in 2026, not quotes. What you actually pay depends on the spring type, the door’s weight, and what we find once we’re looking at the hardware.
| Item | Typical Estimated Range |
|---|---|
| Single torsion spring replacement | $180 – $340 |
| Matched pair of torsion springs | About $360 – $680 |
| Extension spring replacement (per spring) | $180 – $340 |
| Cable repair (often done with springs) | $130 – $250 |
| Roller replacement (if worn) | $110 – $220 |
| Track realignment (if the door shifted) | $120 – $240 |
| General garage door repair (broader jobs) | $150 – $600 |
| Opener repair (if the opener was strained) | $120 – $320 |
What pushes a spring job toward the top of the range? Heavier doors, high-lift or unusual track setups, and springs that are paired with worn cables. A standard single-car door with one torsion spring sits near the low end. A double-car door with two springs, plus a cable that’s frayed from the door running uneven for a while, lands higher. When a spring breaks, the door often comes down hard, and that impact can bend a track or chew up a roller. We check all of it, and we tell you what actually needs replacing versus what can wait.
What keeps it at the low end? A clean single-spring job on a door that’s otherwise in good shape. That’s the most common scenario we see in Pico Rivera, and it’s usually a straightforward visit.
What Affects Spring Replacement Pricing in Pico Rivera
Springs aren’t one-size. The price moves based on a handful of things, and it’s worth knowing them before you call so the estimate makes sense.
- Spring type. Torsion springs (mounted on a bar above the door) and extension springs (running along the sides) are different animals. Torsion is more common on newer doors, and the labor and spring cost differ. We’ll tell you which you have.
- Number of springs. A one-spring door costs one spring’s worth. A two-spring door costs about double, and we usually recommend replacing both at once because a fresh spring next to a tired one wears unevenly.
- Door weight and size. A double-car door needs heavier springs than a single. Heavier springs cost more, and the door’s weight is set by its material and construction, not by guesswork.
- What else broke. When a spring snaps, the door drops. That drop can bend a track, kink a cable, or strain the opener. If we find cable damage, add $130 – $250. Track realignment runs $120 – $240. We quote these separately so you can see exactly what you’re paying for.
- Brand and hardware. Springs themselves are fairly universal, but the surrounding hardware isn’t always. If your door is a Clopay, Amarr, Wayne Dalton, or Raynor, we know the hardware that comes with it and can match parts correctly the first time instead of improvising.
- Access and setup. A garage crammed with stored items or a low-clearance ceiling adds time. It’s not a big factor, but it’s real.
One thing that doesn’t change the price much: the time of year. Pico Rivera’s climate is mild, and springs don’t fail because of weather the way some people assume. They fail from metal fatigue after thousands of cycles, and a door that opens and closes four times a day simply reaches that point. That’s why spring replacement is a predictable, routine job for us, not an emergency scramble.
Why Springs Fail and What to Watch For
Before we get to saving money, it helps to understand what you’re dealing with. A torsion spring is a coiled steel bar under constant tension. Every time the door opens and closes, it flexes. Over thousands of cycles, the metal fatigues and eventually breaks, usually with a sharp bang you can hear from inside the house.
Signs a spring is on its way out:
- A gap in the coil, visible when you look at the spring above the door.
- The door feels extremely heavy when you lift it by hand (never do this with a broken spring, but you may notice it).
- The opener strains, hums, or stops halfway.
- The door drifts down a few inches after you close it.
If you see any of these, stop using the door and call. A door running on a failing spring puts extra load on the opener and cables, and that’s how a $180 – $340 spring job turns into a bigger repair. Call (866) 618-5424 and we’ll book a free estimate.
A word on safety. Torsion springs are under enormous tension, and the tools used to wind and unwind them are specialized for a reason. People get seriously hurt trying to replace springs themselves. This isn’t a job to attempt. A trained technician handles it safely, and that’s what we do. We don’t give step-by-step DIY instructions for springs because the risk to you isn’t worth it.
How to Save on Spring Replacement
There’s no magic discount, but there are real ways to keep the bill down.
- Replace the pair, not just the broken one. It sounds backwards, but replacing both springs at once usually costs less over time than paying for a second service call when the other spring fails a few months later. A pair runs about $360 – $680 versus two separate single-spring visits.
- Fix the small stuff at the same time. If a roller is worn ($110 – $220) or a cable is frayed ($130 – $250), handling it during the spring visit saves a return trip.
- Don’t wait for the second failure. Catching a spring before it snaps means the door hasn’t dropped, so there’s less chance of collateral damage to tracks and cables.
- Get it in writing. A free estimate from us is exactly that. We look at the door, tell you what needs replacing and what doesn’t, and put the number in writing. The written quote is the price.
The single biggest money-saver is honest diagnosis. We’d rather tell you one spring and a set of rollers is all you need than sell you a full overhaul. Right fix, not the most expensive fix. Call (866) 618-5424 for a free estimate and we’ll tell you straight.
Why Brand Knowledge Matters for a Spring Job
A spring job touches more than the spring. The cables, the drums, the center bearing plate, and the opener that’s been straining against a tired door all come into play. That’s where knowing the equipment on your door pays off.
Whether your LiftMaster won’t respond or your Clopay panel is damaged, we’ve seen the setup before. We’re factory-familiar with eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. On the drive side, we know the top three opener makers, LiftMaster, Chamberlain, and Genie, including smart-home platforms like myQ and legacy Craftsman systems that are still running in a lot of older Pico Rivera garages. That means we diagnose brand-specific quirks and match the right hardware rather than guessing.
We’re brand-agnostic. We work on what you already have instead of steering you toward a product we prefer. One call covers the whole door: springs, cables, hardware, opener, and the panels themselves. No second contractor, no finger-pointing when something doesn’t line up.
If your door is older and a repair is on the table, it’s fair to ask whether fixing makes sense or replacing does. Replacing a spring on a door in otherwise decent shape is almost always the right call. When a door has bent panels, a rusted track, and repeated failures, a new door becomes the better value. New door installation in Pico Rivera runs $700 – $2,200, so we’ll walk you through both options honestly. Read more about our Sherwood Garage Door Repair services and what a full-system approach looks like.
How Much Does a Spring Replacement Cost Compared to a Whole New Door?
A spring replacement at $180 – $340 per spring is the low-cost path, and for a door that’s structurally sound, it’s the correct one. A full new door at $700 – $2,200 is the right move only when the rest of the door is failing too. If the panels are bent, the track is rusted through, or you’re on your third major failure in as many years, replacement starts to make financial sense. Otherwise, fix the spring and keep the door. We’ll tell you which side of that line you’re on.
Same-Day Repair and What Happens When You Call
Springs are our most common call, and we keep the work moving. When you call, we’ll ask a couple of questions about the door and the spring, then book you in. We dispatch Sunday through Friday, 7am to 7pm, and same-day service is often available. Call (866) 618-5424. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
On the visit, we inspect the spring, cables, rollers, and track, then give you a written estimate before any work starts. Most single-spring jobs are done in one visit.
FAQs – Spring Replacement Cost in Pico Rivera
How much does it cost to replace a broken garage door spring in Pico Rivera?
$180 – $340 per spring, installed. Most homes have two springs and we usually replace both together, which puts a pair at about $360 – $680. Call (866) 618-5424 for a free estimate.
Is it cheaper to replace one spring or both?
One spring is cheaper up front at $180 – $340, but replacing the pair at about $360 – $680 usually costs less than doing two separate single-spring visits when the second one fails. We usually recommend the pair. Call (866) 618-5424 and we’ll quote both options.
Can you fix a broken spring the same day?
Often, yes. Springs are a routine job for us and same-day service is frequently available. Call (866) 618-5424 early in the day for the best chance. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why does a spring replacement cost more than I expected?
Because a broken spring is rarely the only thing wrong. When the door drops, cables can kink ($130 – $250) and tracks can bend ($120 – $240), and those repairs add to the total. We itemize the estimate so you can see each line before approving. Call (866) 618-5424 for a free estimate.
Can I replace a garage door spring myself?
No. Torsion springs are under extreme tension and can cause serious injury if handled wrong. This is a job for a trained technician with the right tools. Call (866) 618-5424 and let us handle it safely.
Contact Sherwood Garage Door Repair
Spring replacement in Pico Rivera is a routine job for us, and an honest, itemized estimate is the first step. Whether you’re in Pico Rivera and dealing with a loud bang from the garage or just want the door checked before a spring fails, we’re one call away. Call (866) 618-5424 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Learn more about our Pico Rivera service area and how we cover the full garage door system.
Pricing reflects the Pico Rivera market as of 2026. Sherwood Garage Door Repair offers free estimates – call (866) 618-5424.
Written by the team at Sherwood Garage Door Repair, serving Pico Rivera since 2011.
What Our Customers Say
"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Eduardo Garcia"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Beatriz Morales"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Carrie Mercer